Boaters’ Resale Shop of TX 2305 0757.01 ISOTHERM SMART ENERGY CONTROL COMPONENTS

Boaters’ Resale Shop of TX 2305 0757.01 ISOTHERM SMART ENERGY CONTROL COMPONENTS * REMOTE CONTROLLER NOT INCLUDED * COMPONENTS INCLUDED: PROCESSOR BASED MODULE(COD. SED00033AA), POTENTIOMETER (CONTROL SWITCH) and WIRING * SEE ALL 3 PHOTOS * SOLD AS PICTURED * ITEM WAS PRE-OWNED, IN GOOD PHYSICAL CONDITION AND APPEARS TO HAVE NEVER BEEN INSTALLED/USED AND HAS NOT BEEN TESTED *
ONLY COMPONENTS INCLUDED: PROCESSOR BASED MODULE, POTENTIOMETER and WIRING
The Isotherm Smart Energy Control dramatically reduces the on board power consumption for refrigeration appliances. This kit can be easily retrofitted to upgrade the energy saving capabilities of any existing Isotherm refrigeration product.
The Isotherm CRUISE Elegance range provides a pre-formed location in the cabinet
How Isotherm Smart Energy Controller works
The sophisticated, processor-based Isotherm Smart Energy Control technology achieves significant power consumption savings by continuously scanning a set of key environmental factors to determine, through advanced proprietary algorithms, what is the most relevant compressor speed to maximize the performance/battery drain ratio (COP).
The device not only makes your fridge intelligent but also allows the storage of a significant amount of cold energy into the loaded food and drinks. Isotherm Smart Energy Control reduces the cabinet temperature more than a traditional fridge without freezing the food. This is continuously monitored by an air sensor in the cabinet. The cooling energy is stored when a power surplus is available (engine on or connection to grid) and reused first, before the fridge is running on battery. The result is up to 35 % savings due to a more efficient use of the compressor and up to 50 % savings with combined effects of stored cooling energy in food and drinks.
Features
Simple kit, quick and easy to install
Upgradability on Isotherm fridges with Danfoss/ Secop compressors
Up to 35% energy savings solely due to compressor efficiency gains
Up to 50% energy savings with combined effect of cold energy surplus stored in food/drinks
Boost mode for quick cooling
Soft-start to avoid starting surges
No need for eutectic plates

Isotherm Smart Enery Controller Components: Processor-based module to be connected to the Danfoss/Secop compressor.
Potentiometer to activate the Isotherm Smart Energy Control mode.
A dedicated air sensor continuously measures the cabinet air temperature inside the fridge.
Compatabiliity with Isotherm Models

The Isotherm Smart Energy Controller will fit all fridges fitted with the standard ECU
These include :
Cruise Classic 49, 65, 85 and 130
Cruise Elegance 49, 65, 85 and 130
Cruise Clean-Touch 49, 65, 85 and 130

It will not fit the CR42 model